PostHeaderIcon Is there a trick to fixing guttering?

My guttering overflows, no blockage just need to fix it.

Hi, I would suggest getting on a ladder and looking down the gutter to see how it slopes. If it is a long stretch of gutter, and by this I mean over 50 feet long, then the center of the gutter should be pushed up under the drip edge as high as it will go. Each of the ends near the downspouts nearly 20-25 feet aeay from the center high point of the gutter needs to have about a 3/4-1 inch drop from the highest point you can push it up. This will allow the water to slowly run down to the downspouts and not act like a raging river if the slope is too much. Never have the gutter low in the center. If you do need to seal any joints, I recommend the silver Kristies adhesive, that comes in a tube much like caulking. It can be applied on wet surfaces and when it cures, is like steel, so be careful and make sure you get it where you want it. Clean up with a wet rag before the glue sets. One other brief pointer. You need to make sure the bottom flat part of the gutter is actually laying flat. If the gutter is tipped outward, then it will fill up with a lot of water before it ever begins to hit the downspout for drainage. If it rains rapidly, then it will collect at a greater rate than it can drain, thus overflowing. Good luck and be safe.
P.S. Leaving the gutters like this for too long will cause the flow that hits the ground next to the house to soften and loosen the soil around your foundation. If you are unsure that this is occurring, check your sidewalk next to the house (if you have one) and if the sidewalk slopes away from the house, then you lucked out. If it slopes toward the house, chances are that you could have serious foundation problems in the future.

4 Responses to “Is there a trick to fixing guttering?”

  • dawraymee says:

    Depends where it is overflowing.Must be a flow stopping somewhere.If its seeping through a gap fill it eith silicon or mastic sealer as long as the gutter is dry should be ok.
    References :

  • eagle says:

    I hate gutters. They get stopped up and run down the side of the house as well as overflowing behind the gutter and causing the wood trim to rot. I would never put gutters on a house unless it was built in the open far away from any trees. Anyway, gutters are simply drains and the downspout connections are not water tight. They don’t have to be if the downspout is not blocked. The water will freely flow out. If you are having an overflow problem I would check the downspouts first. Take a water hose and stick the end in the top of the downspout. Turn the hose on and see if the spout is really clear. Next, run water with the hose in the gutter end away from the downspout to see if it flows freely to the downspout. I saw a gutter installed with a slight incline and the water overflowed before it got to the downspout.
    The hardware and building supply stores sell tape and sealers to stop dripping joints and connections. Since gravity is the only pressure on the water in the gutter, it doesn’t take much to seal gutters and spouts. Good luck.
    References :

  • wretched_199 says:

    Hi, I would suggest getting on a ladder and looking down the gutter to see how it slopes. If it is a long stretch of gutter, and by this I mean over 50 feet long, then the center of the gutter should be pushed up under the drip edge as high as it will go. Each of the ends near the downspouts nearly 20-25 feet aeay from the center high point of the gutter needs to have about a 3/4-1 inch drop from the highest point you can push it up. This will allow the water to slowly run down to the downspouts and not act like a raging river if the slope is too much. Never have the gutter low in the center. If you do need to seal any joints, I recommend the silver Kristies adhesive, that comes in a tube much like caulking. It can be applied on wet surfaces and when it cures, is like steel, so be careful and make sure you get it where you want it. Clean up with a wet rag before the glue sets. One other brief pointer. You need to make sure the bottom flat part of the gutter is actually laying flat. If the gutter is tipped outward, then it will fill up with a lot of water before it ever begins to hit the downspout for drainage. If it rains rapidly, then it will collect at a greater rate than it can drain, thus overflowing. Good luck and be safe.
    P.S. Leaving the gutters like this for too long will cause the flow that hits the ground next to the house to soften and loosen the soil around your foundation. If you are unsure that this is occurring, check your sidewalk next to the house (if you have one) and if the sidewalk slopes away from the house, then you lucked out. If it slopes toward the house, chances are that you could have serious foundation problems in the future.
    References :

  • philian55 says:

    your guttering should have a fall on it [towards the down pipe]
    check your down pipe is free from dirt
    good luck…..
    References :

Leave a Reply